ACES Custom FPV Racer Quadcopter RTF (w/ Controller)
Fully assembled/wired/configured/tested! No STRESS, Just FLYING!
- Carbon Fiber FlyCat260 Frame
- 4 – iPower MT2204 - 2300KV High Quality Brushless Motors
- 4 – iPeaka 15A OneShot125 Enabled ESC’s with BLHeli Firmware
- Naze32 Rev5 Flight Control Board – Flashed/Configured with Cleanflight
- 3S - 1300 mAh - 25-50C LiPo Battery/Battery Strap/Anti-Slip Battery mat
- Flysight TX5804 - 5.8GHz 400mW 32 Channel Video Transmitter with TX clover antenna
- 1/3" SONY Super HAD CCD 600TVL D-WDR Board Camera with 2.8mm lens
- iMax B6 Balance Charger
- Turnigy 9X 2.4G 9 Channel Transmitter with Module and Receiver. Receiver comes mounted and wired, along with the controller set up and ready to use.
- All you need is your own Diversity Monitor for FPV!
This build is meant for intermediate, and above, Flyers. Will require some knowledge to further tune and alter flight controls. If you are just getting into racing, research and much practice should be expected to master the flight and vast tuning capabilities of ANY racing drone.